folding chair hangers

Project by smiod posted 01-29-2018 01:02 AM 3375 views 0 times favorited 1 comment Add to Favorites Watch

My water heater went out so I cleared out my furnace room so a new water heater could be installed. I had many folding chairs in that room just leaning against the wall. which occasionally slid down to the floor. I decided to build some chair hangers using 1/2” pipe (12” long) along with a 1/2” pipe flange and a pipe cap. I centered the mtg flange first to a 3/4×6” x 20” long board. Mounted this board to the wall making sure I hit studs. 2 screws per side 2 1/2 to 3 ’ long. The bracket will hold 6 folding chairs.

-- stan,michigan

View smiod's profile


15 posts in 1975 days

Embed This Project

HomeRefurbers Code



Preview this project card

1 comment so far

View Smitty_Cabinetshop's profile


14 posts in 1984 days

posted 02-21-2018 03:37 PM

Nice improvement, Stan. I need to make a couple of these as well.

-- A liberal’s disdain for corporate greed is only matched by a conservative’s distrust of unrestrained government.

You must be signed in to post the comments.

DISCLAIMER: All views and comments posted by members are not necessarily those of HomeRefurbers.com or of those working on the site.

Latest Projects | Latest Blog Entries | Latest Forum Topics

LumberJocks.com :: woodworking showcase